Advertisement
Location and Function of Parts
(i) MONITOR SELECT buttons
Press to select the output signal from the WF 1
OUTPUT connector of the CCU-700A/700AP. The
signal corresponding to the lit button is output.
SEQ (sequential): When this button is pressed, you
can monitor the waveforms of the three R, G, and B
signals in sequence on a monitor connected to the
WFl OUTPUT connector.
ENC (encode): When this button is pressed, the SEQ
circuits for WFI OUTPUT is turned off and the
ENC signal is output from the WFI OUTPUT
connector.
mm
The output from the PIXl OUTPUT connector is fixed
to ENC.
G
Camera number/tally indication window
The number of the camera being controlled from this
panel is displayed in orange.
When a red tally signal is sent to the camera, the
number is displayed in black and the background of
the number lights in red.
When a green tally signal is sent to the camera, the
number is displayed in black and the background of
the number lights in green.
When both the red and green tally signals are
simultaneously sent, the left half of the background
lights in red and the right half lights in green.
(i) ALARM indicator
Lights when trouble occurs in the camera system and
the self-diagnostic function activates at the video
camera or the CCU-700A/700AP.
0
CALL button
Press to send a call signal to the video camera, on
which the CALL button lights. The tally lamps on the
camera and the red tally lamp on the CCU-700A/
700AP light when not lit, or go dark when lit.
When the CALL button on the video camera is
pressed, the CALL button on this panel lights and a
buzzer sounds.
� PANEL ACTIVE button
Press and light up the button to permit this panel to
control the camera system (Panel active status).
The IRIS/MB ACTIVE button also lights.
6 (E)
G) Power and output signal select block
□□□
CAM PW
TEST
®
CAM PW (camera power) button
Press and light up this button to turn the power supply
to the video camera ON. (The button promptly flashes
until the camera becomes ready for transmission.)
When you press this button again, it starts flashing and
the power supply is turned off.
@ Signal output select buttons
Press and light up one of these buttons to activate the
test signal generator of the video camera and send the
respective signals.
TEST: To send a sawtooth signal to test the video
circuits
BARS: To send a color bar signal
•MUI
The BARS button takes priority to the TEST button. If
the BARS button is lit, press the button to turn it dark
before pressing the TEST button.
BARS
Advertisement
