Philips FW 316C Instructions For Use Manual page 2

em a i
Important notes for users in the U.K.
Mains plug
This apparatus ts fitted with an approved 13 Amp plug. To change a fuse in this
type of plug proceed as follows:
1 Remove fuse cover and fuse.
2 Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type.
3 Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an
appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5 Amp. if a plug
without a fuse is used, the fuse at the distribution board should not be greater
than 5 Amp.
Note: The severed plug must be disposed of to avoid a possible shock hazard
should it be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue = neutral
(N), brown = live (L}.
As these colours may not correspond with the colour markings identifying the
terminals in your plug, proceed as follows:
e Connect the blue wire to the terminal marked N or coloured black.
e Connect the brown wire to the terminal marked L or coloured red.
¢ Do not connect either wire to the earth terminal in the plug, marked E (or 4) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is clamped over
the sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright Act 1956
and The Performer's Protection Acts 1958 to 1972.
ltalia
Dichiarazione di conformita'
Si dichiara che I'apparecchio FW316C e 339C
Philips risponde alle prescrizioni dell'art. 2,
comma 1 del D.M. 28 Agosto 1995
n. 548.
Fatto a Eindhoven , il 31/1/1998
Philips Sound & Viston
Philips, Glaslaan 2, SFF 10
5616 JB Eindhoven, The Netherlands.
Norge
Typeskilt finnes pa apparatens underside.
Observer: Nettbryteren er sekundert innkoplet.
Den innebygde netdelen er derfor ikke frakoplet
nettet sa lenge apparatet er tilsluttet
nettkontakten.
For 4 redusere faren for brann eller elektrisk
stot, skal apparatet ikke utsettes for regn eller
fuktighet.
te ee - re ee ee