Maintenancefree Battery - Snapper 0 Series Safety Instructions And Operator's Manual

E
G
Figure 7. Steering post
A - Screw
B - Washer
C - Cover
D- Decal (Optional)
E- Steering wheel
F- Bellows
G - Steering post
H- Straight
MaintenanceFree Battery
IMPORTANT:Beforeyou attach the battery cables to the
battery, checkthe battery date. The battery date tells if the
battery must be charged.
1. Checkthe top and the side of the battery for the
location of the battery date (Figure 9).
2. If the battery is put into service before the battery date,
the battery cables can be attachedwithout charging the
battery. See "How To Install The Battery Cables".
3. If the battery is put into service afterthe battery date,
the battery must be charged. See "How To Charge The
Maintenance FreeBattery".
How to Charge the Maintenance Free Battery
,_ WARNING:When you chargethe battery, do not
smoke. Keep the battery away from any sparks.The
fumes from the batteryacid can causean
explosion.
1. Remove the battery and battery tray.
2. Remove the protective cap from the battery terminal.
3. Use a 12 volt battery charger to charge the battery.
Chargeat a rate of 6 amperes for one hour. If you do
not havea battery charger, have an authorized service
center charge the battery.
4. Install the battery and battery tray. Make sure the
positive (+) terminal is on the left side.
How to Install the BatteryCables
WARNING: To preventsparks, fasten the red cable
to the positive (+) terminal before you connectthe
black cable.
Usethe fasteners shown below to install the battery cables.
The fasteners are shown at full size.
Figure 8: Battery cable parts
A - Carriagebolt (Also see 'A' in Figure 3)
B- Wing nut (Also see 'B' in Figure 3)
English
www.snapper.com