Snapper 0 Series Safety Instructions And Operator's Manual page 32

How to Remove the Mower Deck(46 & 52" Models)
1. Push the PTOswitch down to the DISENGAGE position.
2. Open the deck levelposition cover, and move the deck
lift lever to the leveladjustment position (Figure 34).
WARNING:The deck lift lever is spring loaded.
Make sure the deck lift lever is lockedin the LEVEL
ADJUSTMENTposition.
3. Removethe hair pins and the washers from the
adjuster arms (Figure 35). See illustrations "C" and
_D _"
4. Remove the hair pins and washers from the
suspensionlinks. See illustrations "A" and "B".
How to Install the Mower Deck(46 & 52" Models)
1. Push the mower deck under the right side of the unit.
2. Put the mower drive belt around the clutchpulley.
Make sure the "V" side of the mower drive belt is
against the clutchpulley. Also, make sure the mower
drive belt is not twisted. See illustration "F".
3. Attach the front hanger to the axle support with the
hanger rod. Fastenwith the fasteners as shown. See
illustration "E".
4. Make sure the mower drive belt is betweenthe clutch
pulley and the two belt guides, See illustration "F".
5. Attach the suspensionlinksto the lifter assembly.
Fastenwith the washers and hair pins. See illustrations
"A" and "B".
6. Attach the right and the left adjuster arms to the
suspension brackets. Fastenwith the washers and hair
pins. See illustrations "C" and "D".
7. Make sure the mower deck is level. See the instructions
on "How To Level The Mower Deck".
8. Checkthe operation of the PTOclutch. See the
instructions on "How To Adjust The PTOClutch".
e-
e-
e"
,E
o_
Figure 34. Deck tiff lever
A - Deck level position cover (partially hidden)
B - Deck level adjustment position
5. Disconnect the front hanger from the axle support. See
illustration "E".
6. Remove the mower drive belt from the clutchpulley.
See illustration "F".
7. Pull the mower deck away from the right side of the
unit.
8. To operate without the mower deck, move the deck lift
lever to the TOP position.
30
English
www.snapper.com