Installation Manual of GV600 Series Contents Screw installation instructions………………………………….…….………….…………….……..3 Kit Contents………………………………….…….………….……..…………………………..…………...4 Installation on Vehicle ……………………………………………………………..………………..……5 Mounting Configures ……………………….………….………………………………………..…...… 5 Routing of GV600 Device Wire Harness………………………………………………………..6 External Power Connection………………………………………………………………….…….…..7 LED Status of Device …………………………………………………………………………..…..…..8...
Installation Manual of GV600 Series Screw installation instructions Step1: Install the two screws on the front Step2: Install and tighten 4 screws on the bottom shell Note: Install the screws in opposite angles order. Do not fully tighten the screws at the beginning.
Installation Manual of GV600 Series Kit Contents: Tracking Device (internal antenna ) x1 • 18 Pin Power Harness x1 • Temperature Sensor • WIRE DESCRIPTION Definition Color PIN No Connector PIN No Color Definition PWR1 Red/ Green PWR2 AGND Black...
Flatbed: Inside a forward frame rail or under the trailer floor. Find a mounting location in a frame rail or under the trailer floor, with wire routing access that will allow the GV600 Series device towards to a good signal covering position.
Installation Manual of GV600 Series Mounting Configures Use the GV600 Mounting plate as a template, mark four holes with a pencil for mounting holes Drill mounting holes with a #29 drill bit Screw the plate to the chassis by using the Flat head screws x4 ...
Installation Manual of GV600 Series Routing GV600 Device Wire Harness Nose Mounting in trailer: Remove the bolts and open the housing’s cover Choose the best harness routing way Run alongside the trailer harness through the housing’s stock cable grommet.
Installation Manual of GV600 Series External Power Connection Connect the power wire (Red) and ground wire (Black) to the external power supply There are two pairs of power cable (PWR & AGND) that are included in the 18pin wire harness. You can select a pair of power cable (PWR &...
Installation Manual of GV600 Series LED Status of Device LED Lighting Definition: Device status LED status Device is searching CELL network. Fast flashing (Note 3) Device has registered to CELL network. Slow flashing(Note 4) CELL (Note 1) Modem power shutdown.