Page 1
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual QLM100 User Manual EGPRS/LTE Cat-M1/LTE Cat-NB2 Module TRACQLM100UM001 Version: 1.00 TRACQLM100UM001 - 0 - VeryPDF Software Demo Version (http://www.verypdf.com)
Page 2
Release Document Control ID TRACQLM100UM001 G eneral Notes Queclink offers this information as a service to its customers, to support application and mers, to suppor , to supp engineering efforts that use the products designed by Queclink. The information provided y Queclink.
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual 0. Revision History Version Date Author Description of Change 1.00 2021-04-23 Wokky Lin Initial TRACQLM100UM001 - 5 - VeryPDF Software Demo Version (http://www.verypdf.com)
QLM100 User Manual 1. Introduction QLM100 module is an LTE Cat M1/ Cat NB2/ EGPRS module and a baseband processor platform based on ARM Cortex A7. The maximum dominant frequency is up to 800MHz. It provides data connectivity on LTE-TDD/LTE-FDD/GPRS/EDGE networks, and supports half-duplex operation in LTE networks.
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual 2. Product Overview 2.1. Description QLM100 is an embedded IOT wireless communication module. Figure 1. Appearance of QLM100 top gure 1. Appearance of QLM100 t pearance of QLM100 Figure 2. Appearance of QLM100 bottom...
Page 9
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual Figure 3. QLM100 Pin map Figure 3. QLM Figure 3. QL Table 2: QLM100 Pin description Table Table PIN NO. QLM100 Net Name QLM1 Description PSM_IND Power saving mode indication General purpose analog to digital...
Page 10
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual output interface UART2_TX Transmit data UART2_RX Receive data W_DISABLE# Airplane mode control Application processor sleep state AP_READY Detection Indicate the module’s STATUS Operation status Indicate the module’s NETLIGHT Operation status DBG_RXD Receive data...
Page 11
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual output interface General purpose input/ GPIO38 output interface General purpose input/ GRFC_2 output interface General purpose input/ GRFC_1 output interface General purpose input/ GPIO52 output interface General purpose input/ GPIO25 output interface...
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual 3. Getting Started 3.1. Module & EVB The QLM100_EVB can be used to test module. Figure 4. EVB & Module 3.2. Power on the Module Connect the 12V charger with EVB, switch the POWER to ON and then press the power...
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual key. Note: The Force_USB should be on switch to the side as the Figure5 shows. Figure 5. Power on the module Figure 5 igure Power 3.3. Send command by the USB Send command by Send comman Connect the EVB with micro USB cable interface to send command to module.
Page 15
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual Figure 6. Connect USB with module . Connect USB with module ct USB with mod TRACQLM100UM001 - 14 - VeryPDF Software Demo Version (http://www.verypdf.com)
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual Figure 7. send command by QCOM 3.4. Upgrade the firmware step1. Connect 12V charger and USB Cable. step2. Switch the Power to ON, switch the Force_USB to up as Figure 8. step3. Press the power key to turn on the module.
Page 17
VeryPDF Software Demo Version (http://www.verypdf.com) QLM100 User Manual step4. Use the tool " Queclink_Firmware_Upgrade_Tool_MDM_V1.35" to upgrade. Figure 8. Upgrade the firmware Figure 8 gure Upgrade the firmw Upgrade the fi TRACQLM100UM001 - 16 - VeryPDF Software Demo Version (http://www.verypdf.com)
Page 18
“Contains transmitter module FCC ID: YQD-QLM100 ”. Additionally, the following statement should be included on the label and in the final product’s user manual: “This device complies with Part 15 of the FCC Rules.
Page 19
FCC Declaration This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
Page 20
The device itself has antenna, customer can use the PIFA antenna with antenna gain isn't greater than 3 dBi. Lable and compliance information If this certified module is installed inside the host device, then the outside of the host must be labeledwith ''Contains FCC ID: FCC ID: YQD-QLM100 "...