Wolf SRT304 Installation Instructions Manual page 14

W O L F
S U R FAC E
I N I T I A L L I G H T I N G
The surface burners use electronic igniters in
place of standing pilots. When the rangetop
control knob is pushed in and turned to the
HIGH position, the system creates a spark to
light the burner. This sparking continues until
the electronic ignition senses a flame.
Be sure to place the burner heads on each
burner base and position the burner grates
over the burner bases and heads before
lighting.
To check operation of the surface burners,
push in and turn each control knob to the HIGH
position. The flame should light within four
seconds.
If the burners do not light properly, turn
control knob to the OFF position. Check that
the burner caps are in the proper position.
Check that the power supply cord is plugged in
and that the circuit breaker or house fuse has
not blown. Check that the shut-off valve is in
the ON position. Check operation again; if the
burners do not light properly at this point,
contact a Wolf authorized service center.
IMPORTANT NOTE: Initial lighting of the
surface burners may take slightly longer, as air
in the system must be purged before gas can
be supplied to the burner.
14
S E A L E D B U R N E R R A N G E TO P
B U R N E R S R E M OV I N G T H E R A N G E T O P
Be sure to disconnect the gas supply and
electrical connections before removing
the rangetop.
If removing the rangetop is necessary for
cleaning or service, shut off the gas supply.
Disconnect the gas supply and electrical
connections to the unit, then remove the
rangetop. Reinstall in the reverse order and be
sure to check the gas connection for leaks.
Refer the Wolf Sealed Burner Rangetops
Use & Care Information included with the
rangetop for cleaning recommendations.