Download Print this page

Electrical Shock Hazard - Wolf SRT304 Installation Instructions Manual

30", 36", 48" sealed burner rangetops
Hide thumbs Also See for SRT304:

Advertisement

I N S TA L L AT I O N
I N S T R U C T I O N S
E L E C T R I C A L
R E Q U I R E M E N T S
ELECTRICAL SHOCK HAZARD –
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Do not use an adapter.
Failure to follow these instructions can
result in electric shock, fire or death.
The Wolf sealed burner rangetop requires a
110/120 V AC electrical supply to operate the
electronic ignition system. The 6' (1.8 m)
power supply cord provided with the rangetop
is equipped with a 3-prong, grounded plug for
protection against shock hazard. The service
should have its own 15 amp circuit breaker.
IMPORTANT NOTE: You must follow all
National Electrical Code and gas regulations.
In addition, be aware of local codes and ordi-
nances when installing your services.
Grounding Plug
Grounding-Type
Electrical Outlet
Electrical ground
Dimensions in parentheses are in
millimeters unless otherwise specified.
R E C O M M E N D E D G R O U N D M E T H O D
IMPORTANT NOTE: This appliance must be
properly grounded to avoid shock hazard.
The rangetop is equipped with a 3-prong
ground plug. To minimize possible shock
hazard, the cord must be plugged into a
mating 3-prong ground-type outlet, grounded
to conform with the National Electrical Code,
ANSI/NFPA 70 latest edition, or Canadian
Electrical Code (CSA) and all local codes and
ordinances. Refer to the illustration below.
You must have a properly grounded, 3-prong
outlet installed by a qualified electrician. A
ground fault circuit interrupter (GFCI) is not
recommended and may cause interruption of
operation.
IMPORTANT NOTE: Do not ground to a gas
pipe.
IMPORTANT NOTE: Reverse polarity will
cause nuisance clicking when power is turned
on to the unit.
W I R I N G D I A G R A M
The wiring diagram covering the electrical
circuit is located on the inside left wall of the
rangetop.
I M P O R TA N T
N O T E
You must follow
all National
Electrical Code
regulations. In
addition, be aware
of local codes and
ordinances when
installing your
service.
13

Advertisement

loading

This manual is also suitable for:

Srt366