Wolf BBQ242BI Installation Instructions Manual page 18

W O L F
I N S TA L L A T I O N
IMPORTANT NOTE: To ensure a safe and
proper installation, the following checklist
should be completed by the installer to be
sure that no part of the installation has been
overlooked.
Any questions or problems about the installa-
tion should be directed to your Wolf dealer or
the Wolf Customer Service Department at
800-222-7820. You can also visit our website at
wolfappliance.com.
All internal packaging has been removed
All shipping restraints have been removed
from the burners
Radiants are oriented properly over grill
burners with triangular cut-out positioned to
the rear of the grill
Specified clearances to any combustible
materials have been maintained
Batteries are installed behind the ignition
buttons
All burners light properly, individually and
with adjacent burners lit
All flames appear normal
The drip tray slides freely and the grease
collection tray is properly placed
The correct pressure regulator is connected
for natural or LP gas and set for 5" (12.5 mb)
WC for natural gas or 10" (25 mb) WC for LP
gas
The LP gas cylinder is in an upright position
and the hose is not kinked
The grill has been tested and is free of gas
leaks
The homeowner has been informed of the
gas supply shut-off valve location
18
G A S B B Q G R I L L S
C H E C K L I S T T R O U B L E S H O O T I N G
IMPORTANT NOTE: If the gas BBQ grill
does not operate properly, follow these
troubleshooting steps:
Verify that gas is being supplied to the BBQ
grill.
Check the gas supply and electrical
connections to ensure that the installation
has been completed correctly.
Check that gas valves are turned to the ON
position.
Follow troubleshooting procedures as
described in the Wolf Gas BBQ Grills Use &
Care Information.
If the BBQ grill still does not work, contact a
Wolf authorized service center. Do not
attempt to repair the grill yourself. Wolf is
not responsible for service required to
correct a faulty installation.
Be sure to disconnect the electrical and
gas supply before servicing.
Surface burners can be lit manually with
a match. Use extreme caution.