Samsung AC BN6DCH Series User Manual page 16

Cleaning and Maintaining
Problem
The air is not cool or
warm enough.
16
English
DB68-11306A-00_IB_CAC Universal 360_AA_EN.indd 16 DB68-11306A-00_IB_CAC Universal 360_AA_EN.indd 16
• In the Cool mode, cool air does not come out if the set temperature is higher
than the current temperature.
– AR-EH0**, AR-EC0** remote control: Press the Temperature button
repeatedly until the set temperature (minimum: 64℉(18℃)) is set to lower
than the current temperature.
– AR-KH0** remote control: Press the Temperature button on the remote
control. Then rotate the Wheel until the set temperature
(minimum: 64℉(18℃)) is set to lower than the current temperature.
• In the Heat mode, warm air does not come out if the set temperature is lower
than the current temperature.
– AR-EH0**, AR-EC0** remote control: Press the Temperature button
repeatedly until the set temperature (maximum: 86℉(30℃)) is set to
higher than the current temperature.
– AR-KH0** remote control: Press the Temperature button on the remote
control. Then rotate the Wheel until the set temperature
(maximum: 86℉(30℃)) is set to higher than the current temperature.
• Both cooling and heating do not operate in the Fan mode. Select the Cool,
Heat, Auto, or Dry mode.
• Check whether the air filter is blocked with dirt. A dusty filter may decrease the
cooling and heating efficiencies. Clean the air filter frequently.
• If a cover is on the outdoor unit or any obstacle is present near the outdoor
unit, remove them.
• Install the outdoor unit in a well-ventilated place. Avoiding places exposed to
direct sunlight or close to a heating appliance.
• Place a sunscreen over the outdoor unit to protect it from direct sunlight.
• If the indoor unit is installed in a place exposed to direct sunlight, pull the
curtains on the windows.
• Close the windows and doors to maximize the cooling and heating efficiencies.
• If the Cool mode is stopped and then started immediately, cool air comes out
after about 3 minutes to protect the compressor of the outdoor unit.
• When the Heat mode is started, warm air does not come out immediately to
prevent cool air from coming out at the beginning.
• If the refrigerant pipe is too long, the cooling and heating efficiencies may be
decreased. Avoid exceeding the maximum pipe length.
Solution
2021-09-03 오전 8:52:42 2021-09-03 오전 8:52:42