Table of Contents
Advertisement
Surround (cont.)
Dolby Pro-Logic Surround Connection
Amplifier
= E
PTV Speakers
(Center)
TERMINALS O
OF RECEIVER
Right Front
EMEN
MEE
EET
CS
Left Front
C
Z)
^os:
DIGITAL
AUDIO
:
:
(PCWAC-3)
.
ANTI"
e
©
SPLIT
OuT
Bare Wire
Insulation
ave"
(10mm)
WIRE END DETAIL
(1)
PUSH AND HOLD DOWN BUTTON
(2)
INSERAT
BARE
WIRE
INTO
HOLE
AND RELEASE BUTTON.
Right Rear
2
Left Rear
Simaund Speaker
Surround Speaker
1.
Connect the Audio amplifier speakers and the surround rear
speakers to the PTV as shown in the diagram above.
2. The PTV Volume should be set at a normal listening level.
;
NOTE: The PTV main audio volume control will vary all audio B
channels at the same time, similar to a master volume É
control.
:
3.
Setup the Dolby Pro-Logic Surround menu system as follows:
MODE: PRO-LOGIC
SETTINGS: WIDE or NORMAL
(Refer to the Surround Pro-Logic Mode section for setting up F:
menu procedures).
i
4.
Balance the system by using the Surround Pro-Logic Test Tone
[E
menu. Adjust the levels of the Optional Amplifier front LEFT and
RIGHT Speakers, PTV Center channel Speaker, and the LEFT
and RIGHT Rear Surround Speakers to be equal.
(Refer to the Surround Pro-Logic section for the procedure to
adjust Test Tone levels).
-26-
Advertisement
Table of Contents
