Electrical Wiring - Riello RLAS 650-800 FGR 6 Installation, Use And Maintenance Instructions

2.4

Electrical wiring

For the electrical wiring refer to the burner electrical diagram or to
Fig. 5 and proceed as follows:
 remove the cover from the air servomotor 1) Fig. 2, page 3;
 connect the WG53 cable to the -X2 connector;
/, +  + 0 8 + 8 +
:
14 +67 64
Connect the temperature probe using the connector No. 8018
supplied with the kit. The probe connection does not require any
wiring while for the electrical panel, see Fig. 6 or the burner electric
diagram.
20156844
Conversion kit from /EV to /EV FGR operation
5DEA@
/, +  + 0
/, +  + 0
./4 +67 64
4
If the oxygen kit is installed, wire the WG54 cable supplied with the
kit to the -X2 connector of the FGR servomotor and return to the
burner electrical panel of the burner at the terminal board, see the
burner electric diagram.
5
:
8 + 8 + 5DEA@
5DEA@
8 + 8 +
:
:
GB
9#!
//#$" $"
:
/, +  + 0 8 + 8 +
!

2J
S9812
5!
5DEA@
Fig. 5
S9813
"
Fig. 6