Advertisement
INFORMATION ABOUT INTERFACES
•
E)(phim~tion:
When receiving this command, the
DPX~3300
outputs the error codes about the
RS~232C
interface, shown in Table
8~5,
At the Same time, errors a
Error
o
An I/O error has not occurred,
Error contents
10
~~~~~+-c~~~~~~~~.~~~~~~~~~~~~~~.~~~~~~~~~~~~
While an output request is executed, another comm<lnd requesting output is received, but only the
first command is valid,
11
12
A device control command error has occurred.
When <l device control command parameter is unsuitable. (The parameter causing the
to default value,)
set
15
16
13
When a parameter has overflowed.
14
When too many parameter is input, or paramti)tti)r is not terminat!1ld by " : ".
When a framing ti)rror, parity error, or overrun error has occlJrred during reception of data.
--~~-~~~~.~.-+--~.~~~~~~~~~~~~~~~~~~~~~.~~~.~~~~~~.~~~
When the
I/o
buffer has overflowed. (In this CaSE! normiJl qrawing operation is impossible,)
Table 8-5
When receiving this command, the DPX·3300 outputs the current size of the 1/0
buffer to the computer, usually outputting " 024 bytes, But you can change the
of the 1/0 buffer in a range from 0 to 15358 by either
.T
or
.@
cormnand,
Advertisement
