Internal System Alignment Routine - Yaesu FT-2200 Technical Supplement

.Internal System Alignment Routine----
Tight
tl
I
.-. C.•
•=
t:fL
_, fL.
f
Adjust for a -3 dB signal, then press
coL
~ ~F
~u.
PRI
Scan Center-Stop
+Offset
tl
I
.-. C.•
+
.-.
'
,- ,-
--
fillED
•n•••IJJ•••lfl•••
Inject a +20 dB signal of 146.003 MHz(
±
3.5
kHz deviation of a 1-kHz tone), then press
coL
~Z ~MF
=>
u.
PRI
-Offset
. -.
' ,-
,-
--
fillED
•o•••IJJ•••lfl•••
Adjust the generator frequency to 145.997
MHz, then press
coLL
=>
Mc5z.
DTMF PRI
TX Power Output Level Adjust.
High Power Adjust
t f l
.-. C.•
Connect a dummy load wattmeter to the
antenna connector, then key the transmitter
and adjust the output power level for 48 watts
by rotating the DIAL knob on the transceiver.
Press
~LL
=>
M()z.
DTMF PRI
Mid-Power Adjust
("MID"
indicator displayed)
• ., t
.-. C.•
MID
Key the transceiver and adjust for 25 watts,
h
C~L Ml::iz
t en press
CJ
~
o .
DTMF
PRI
Low Power Adjust
• ., t
.-. C.•
"-'
Key the transceiver and adjust for 5 watts,
then press
cOL
~
Mc5z.
DTMF
PRI
This completes the internal alignment rou-
tine, to save all settings and exit, press
coL
then
DTMF
~2:
,
the normal frequency display will re-
turn .
2-B-----------------------------------------------------------------
Fl'-2200 Technical Supplement