Installation And Setup - Klarstein MATTERHORN BREEZE Manual

EN
28
Article 10045292 10045293, 10045294
Housing
Shelf
Feet

INSTALLATION AND SETUP

Before first use
• Before use, first remove all packing materials, including the bottom padding,
foam cushions and adhesive strips inside the refrigerator.
• Tear off the protective film on the refrigerator door and on the cabinet.
• Keep the device away from heat and direct sunlight. To avoid rusting, do not
place the device in damp or wet places.
• Do not spray, wash, or place the refrigerator in a damp location where it
may be subject to splashing water. This can affect the electrical insulation
properties.
• The refrigerator must be placed in a well-ventilated place where the floor is
flat and solid. Use the adjustable feet to compensate for slight unevenness.
• The clearance to the ceiling should be at least 30 cm and the device should be
placed at a distance of more than 10 cm against a wall so that the heat can
dissipate.
Upper suspension
Door
Door seal
Lower suspension