Advertisement
@ Vibration
Do not use the unit in a location where there is considerable
vibration.
@ Magnetism
Do not bring the unit near magnetic fields or electrical
equipment which generates strong magnetic fields.
@ Temperature
Under no circumstances use the unit in a very hot or coid
location or a location which is exposed to direct sunlight.
This is because the performance of the unit may be
degraded.
@ Humidity
Electronic equipment does not readily withstand humidity.
Do not install the unit in a very humid location or a place
where rain is likely to reach it. Under no conditions allow
liquids to spill into unit; extensive damage may occur.
Cleaning the unit
Before cleaning the unit, turn "OFF" the Power Switch, and
be sure to pull out the Power Plug from the power outlet.
Clean the cabinet using a soft cloth. If the cabinet is very
dirty, immerse the cloth in a diluted solution of dishwashing
detergent, wring it hard, and wipe off the dirt, then finish the
cabinet with a dry cloth. Do not use paint thinner or benzine.
@ Storing the unit
41. Do not store the unit in a very hot or cold location.
2. Under no circumstances leave the unit outdoors.
3. Be sure and remove the cassette tape from the unit.
4
. To prevent a possible breakdown, when not using the
unit for some time turn "OFF" the Power Switch and be
sure to withdraw the Power Plug from the power outlet.
(Under no circumstances pull directly on the power cord
because of the risk of breaking the conductor inside.)
Bi installation Conditions
1. Use the unit in a horizontal position.
2. Donotbiock the ventilation holes in the unit. To improve
air circulation, ventilation holes are provided at the top of
the unit. Keep the rear of the unit at least 15 cm, and the
sides at least 5 cm, away from any wails. Also, do not
block up the ventilation holes underneath the unit with
carpet, etc.
3. Before moving the unit from one place to another, be
sure and remove the cassette tape.
4. To ensure that the unit can be used without breakdown,
do not place objects on top of it.
5. When using the unit on a base, provide a firm base.
6. If you abruptly warm
the room
in which
the unit is
installed using a gas stove, etc., or quickly move the unit
from a cold place to a warm place, the resulting sudden
change in temperature may cause condensation and
prevent the tape from traveling properly. As far as
possible, therefore, use the unit under conditions in
which the temperature does not change abruptly.
If
condensation occurs inside the unit, the Auto OFF Lamp
(condensation indicator) will light, and the unit will stop
operating. In such a case, wait until the lamp goes out.
@ When using the unit, do not block the ventilating holes at
the top.
@ When mounting this unit on a rack, use a rack which is
provided with a fan.
@ In the event of an abnormality,
immediately turn the
Power Switch "OFF" and remove the Power Plug from
the power outlet, then contact the shop where you
purchased
the unit. If you continue to use the unit
without removing the cause of the abnormality, the
extent
of the fault may
increase
or an
unforeseen
accident may result.
Advertisement
