Advertisement
ACCUDUAL
Install ACD-76300/301 into system
Follow the following instructions to establish the connection.
1. After RAID box is fully configured.
2. Power down your host computer.
3. Mount the RAID box into the system.
4. Connecting the SCSI/IDE cable from system computer to RAID box.
5. Connecting DC power from system power output to the DC power input
connector of power-delay module.
6. Connecting power cable that attached with package from end of DC power
output of power-delay module to RAID box.
(Please refer to below figure for instruction 5 and 6.)
7. After completing the above steps. Refer to next section for Starting using the
RIAD box.
Start using RAID box
Application 1: Two new disk drives.
1.
Insert both hard drives into the RAID box.
2.
Power on the host computer.
3.
After system boot up, the RAID box will be recognized by host system.
And system treats it as a single disk.
4.
Partition and format the array under OS before it can be used.
Application 2: Installing one hard drive with data and one new
hard drive.
1.
The new hard drive must be the same capacity or larger capacity than
the hard drive that with data.
2.
Insert hard disk that with data into the top slot and leave bottom Slot
empty. This identifies the disk with data as the source drive. (The host
computer must be in power-off status.)
3.
Power on the host computer.
4.
Insert the new hard drive into bottom slot. This identifies the newly
inserted hard drive as a target disk.
5.
The RAID box will immediately begin mirroring the data from the
source hard drive to the new hard drive in bottom slot. Any old data on
the newly inserted hard drive will be lost, and is overwritten with the
mirror image of the source drive.
Note
If you have installed non-identical hard drives, your
computer will recognize RAID box as a single hard disk
with a capacity equal to the smaller hard disk drive
installed in the RAID box.
ACD-76300/ACD-76301/ACD-76302 RAID BOX
Advertisement
