olympia electronics BS-655/A Manual

Mounting Base
5 5
From the zone
of the panel
Connect the power cables (minding the correct polarity) according to the requirements of
the installation.
CONNECTION
1. + IN/OUT : It is connected to the zone of the panel or to the (+ IN/OUT) contact of
the previous detector.
2. - IN : It is connected to the zone of the panel or to the (- OUT) contact of the
previous detector.
3. - OUT : It is connected to the next detector (- IN) or if it is the last one to the terminal
resistor.
4. - R : It is connected with BS-572.
5. : Connected to the cable's shield (when shield is used).
Connection
If the power of the detectors is turned off, wait for 3-5 seconds before you turn the power on
again.
3
Place the detector carefully so that the side marks are aligned and rotate the detector
clockwise until it locks. Provide power to the device and after 3-5 seconds it is ready for
operation.
4
4
4 921655004, 921657002, 921660004_08_006
Connection
Technical Characteristics
with external
LED
TYPE
+
OPERATION VOLTAGE
START UP POWER CONSUMPTION
STANDBY CONSUMPTION
R ALARM CONSUMPTION
SMOKE CONCENTRATION SENSITIVITY
TEMPERATURE SENSITIVITY
CLASS
INDICATORS
OUTPUT
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATING TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
CONSTRUCTION COLOR
EXTERNAL DIMENSIONS(
TYPICAL WEIGHT
GUARANTEE
BS-655/A
Optical smoke detector
EN 54-7:2018
DoP: 921655004_59_002
BS-657/A
Optical smoke & rate-of-rise heat detector
ΕΝ 54-5:2017+Α1:2018 , ΕΝ 54-7:2018
DoP: 921657002_59_002
BS-660/A
Rate-of-rise heat detector
ΕΝ 54-5:2017+Α1:2018
DoP: 921660004_59_004
Warranty
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical
leaflet, which accompanies each product. This warranty ceases to exist if the buyer does not
follow the technical instructions included in official documents given by Olympia Electronics or if
the buyer modifies the goods provided or has any repairs or re-setting done by a third party,
unless Olympia Electronics has fully agreed to them in writing. Products that have been damaged
can be returned to the premises of our company for repair or replacement, as long as the
warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not
charge the buyer depending on the reason of defection. Olympia Electronics reserves the right to
charge or not the buyer the transportation cost.
5
BS-655/A BS-657/A
BS-655/A/C BS-657/A/C
Optical
Optical
smoke & rate-of-rise
smoke detector
heat detector
17-30V DC
1mA for 2 sec
90μA
12mA (with activated on board LED)
0.107 dB/m 0.107 dB/m
-
ο
57 C
-
Α1R
Alarm LED
To panel / to external LED (BS-572)
IP42
EN 54-7, EN 54-5
EN 54-7
ο
-40 to 70 C
Up to 95%
ABS/PC
WHITE ANTHRACITE (/C)
x height)
103 x 48mm 103 x 55mm
158 gr. 158 gr.
2 years
21
1293
21
EGINIO
1293
PIERIAS
60300
23
GREECE
1922
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.com
info@olympia-electronics.gr
921655004, 921657002, 921660004_08_006
BS-660/A
European
BS-660/A/C
manufacturers
Rate-of-rise
heat detector
-
ο
57 C
Α1R
EN 54-5
103 x 48mm
143 gr.
SMOKE DETECTORS &
RATE OR RISE HEAT DETECTORS
Thank you for your trust in our products
Olympia Electronics - European manufacturer