Advertisement
Controller: Adjusting the actuator CCW position
Follow these instructions to adjust the CCW position controlled by the 105 Proportional Controller (standard operation).
Proceed to the next page to adjust the CCW position controlled by the travel cam.
(Assumes actuator is powered up, running and is at the default display, showing position).
Press the joystick LEFT twice...
Press the joystick DOWN three times...
Press the joystick RIGHT once...
Press the joystick DOWN twice...
Press the joystick RIGHT once...
(actual position in steps)
Press joystick UP and HOLD to drive further CCW or press DOWN
and HOLD to drive further CW. The adjusted CCW position MUST be
between 2500 and 4000 steps.
When the correct CCW position is established,
press the joystick IN...
Press the joystick LEFT twice...
Press the joystick UP three times
Press the joystick RIGHT once... DOWN twice,
then RIGHT once, the display will now show %
of CCW position (0.0 = Fully CW)
Notice
Performing an Auto Calibration after this procedure will ERASE this custom stop set point and will return to the
factory default setting. For this reason, you CANNOT run an Auto Calibration procedure at any time after this setting has
been changed.
realtiOe
Display reads:
SET Travel
Display reads:
Auto Set
Display reads:
Full open
Display reads:
00 to 4096
Display reads:
done
Display reads:
SET travel
Display reads:
realtiOe
Display reads:
00 to 100
Page 9 of 16 P2/3 HV Proportional Series
Advertisement
