Heathkit SG-8 Assembly And Operation Manual page 15

( ) Connect the other wire to TB2 (NS).
( ) Connect a 47 £2 resistor from Nil (NS) to N (NS).
( ) Connect a 47 ft resistor from Nil (S) to N3 (NS).
( . ) Connect a 680 ft resistor from N3 (S) to N (NS).
( ) Connect a 680 ft resistor from N (S) to N7 (NS).
( ) Connect
( ) Connect a bare wire to N2 (S). Cover wire with a 2 1/2 " length of spaghetti.
( ) Connect the free end of the yellow transformer wire to the rear pilot light terminal (NS).
( ) Connect the remaining bare wire of coil E3 to TCI (NS). (Use sleeving. )
Run wire along rear of chassis as shown in Pictorial 3, to TD1
( ) Connect a short bare wire from G1 (S) to K12 (S).
( ) Connect the free end of the wire coming from R4 (see Pictorial 2) to G3 (S).
( ) Connect the free end of the wire coming from TAI (see Pictorial 2) to TD2 (NS).
( ) Connect a short bare wire from G4 (S) to the solder lug adjacent to the tube socket (NS).
( ) Connect a .01 gfd ceramic condenser from G (NS) to TD2 (S).
( ) Connect a 600 ft resistor from G (S) to TD1 (S).
( ) Connect a 100 Kft resistor from G6 (NS) to the solder lug (NS).
( ) Connect a .01 gfd ceramic condenser from G6 (S) to K2 (S). (Use sleeving. )
( ) Connect a 330 ft resistor from G7 (S) to the solder lug (NS).
( ) Connect a 390 Kft resistor from K8 (NS) to K10 (S).
L
( ) Slip
Page 13
i
I
I
a 7/8 " length of spaghetti over each lead of the .01 gfd ceramic condenser, and connect
the condenser from K8 (S) to L3 (NS).
a bare wire to N7 (S). Cover with a 1 1/2 " length of spaghetti and connect to M2 (S) .
( ) Connect a bare wire to Ml (S). f<un the wire through Nil (NS) to the solder lug adjacent to
the large panel cutout (S).
( ) Connect the free end of the wire coming from R (see Pictorial 2) to the same pilot light
terminal (S).
( ) Connect the free end of the wire coming from TA3 (see Pictorial 2) to M3 (S). Run wire as
shown in Pictorial 3.
( ) Connect a short bare wire from the lug on the RF OUT connector (S) to the pilot light ter ­
minal nearest the panel (S).
( ) Connect a wire to TCI (S).
(NS).
Run wire
through grommet P and connect to the center terminal of the RF OUT connection (S). See
Pictorial 4.