Heathkit SG-8 Assembly And Operation Manual page 11

( ) Connect a bare wire from BR3 (S) to C3 (S).
( ) Connect a bare wire from BR4 (S) to D3 (S).
( ) Connect coil E3 from BF (S) to BR (S).
i
(
( ) Connect coil El from BF6 (S) to CC3 (S).
( ) Connect coil E2 from BR6 (S) to CC4 (S).
This completes the sub-chassis wiring.
ASSEMBLY OF CHASSIS
Oo Oo
Oo Oo
o
e e
Figure 6
NOTE: Refer to Figure 6.
( ) Install 3/8 rubber grommets in holes A, C, D, E, F and P.
( )
Position as shown
( )
Page 9
X
If
: «
Mount a 7-pin miniature socket in hole G, using '3-48 screws and nuts,
in Figure 6.
I
i
I
!
© Q
O o
1 fol 2 ® rmP) 3
)
) Cover one bare lead from coil E3 with a 3 1/2 " length of sleeving, and connect to DI (S) .
Leave the other end free.
Mount the seleniuip, rectifier with the side having the plus or cathode marking facing out ­
ward from the back of the chassis. Use a 1 " 6-32 screw through the dimpled hole in the
rear apron of the chassis. Fasten with a lockwasher and nut. Position as shown in Figure
6.
0°
' l® 2