Heathkit SG-8 Assembly And Operation Manual page 14

( ) Connect the other red wire to the solder lug directly below the rectifier (NS).
( ) Connect either yellow wire from the transformer to this solder lug (NS).
( ) Connect the single negative wire to the solder lug (S).
( ) Connect the two positive wires of the condenser to TCI and TC2 (NS).
( ) Connect a wire from the positive rectifier terminal (S) to TC2 (NS).
( ) Connect a 3.3 Kft 1 watt resistor from TC2 (S) to TCI (NS).
( ) Connect a .00 jxfd disc ceramic condenser from TCI (NS) to the adjacent solder lug (NS).
Connect one pair of wire ends to the two switch
Connect one wire to TB1
I
c© o
©
Page 12
PICTORIAL 4
!
J
I
■
i
?■
.■
i
•i
■
( ) Twist two wires about 10 " long together,
terminals on the back of control M (S).
( ) Run the other yellow lead as shown in Pictorial 3, through the grommet P. Leave the other
end free.
i
I
I
©
(So
( ) The 20-20 gfd 1 0 volt filter condenser has two leads on the end marked ' ' positive, " and
one lead on the other end. The condenser is mounted between the solder lug and the ter ­
minal strip TC as shown in Pictorial 3.
SO
( ) Run the wires as shown in Pictorial 3 to the terminal strip TB.
(S).