Rear Panel Jacks - Hitachi 46F510 Operating Manual

REAR PANEL JACKS
ANTA
TO
DONVERrER
ANT B
@
f
(
INPUT 1
INPUT 2
INPUT 4
MONITOR
L7:
T
DVl HDTV
PR P_ V
@@@ ,
R (MONO)/L
@ @
PR PB Y_IOE0
@@@ +
R (NIONO)/L
I I
I I
R L VIDEO
@@@
LAUD[o. -- /
1_ Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can
be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a
sub-picture.) The antenna output labeled "TO CONVERTER" allows the ANT A connection to pass directly to a different source
such as a cable box, only when ANT B is displayed as a main picture.
@ AudiolVideo Inputs !, 2, 3 and 4
The VDI-VID4 buttons wNI select each video source each time they are pressed. Use the audio and video inputs to connect
external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert the audio cable
into the left audio jack.)
i NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a time.
MONITOR
OUT
These jacks provide fixed audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video
output.
NOTE: S-VIDEO Output may be used for recording, only when the input is of S-VIDEO type. 1
J
J
(_ AUDIO TO HI-FI Output
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be
controlled by the television's main volume.
(_) S-VIDEO Inputs 3 and 4
Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.
iTiT
i!Li!
iiiii
ijjjjjjj