Table of Contents
Advertisement
If a backup connection is desired, it can be selected at this point as well. The same two options
are available: Automatic redundancy, where the 9220 will switch by itself after a configurable
timeout, and Manual redundancy, where the operator is responsible for switching. If Automatic
redundancy is selected, a field to configure the switch time becomes available. Valid values are
from 2 to 45 seconds. This is illustrated below.
If you select Automatic or Manual for the Backup Connection, a second set of Source
Port/Source Stream drop-down menus are displayed, to select the backup source. These operate
in exactly the same fashion as the primary source selections. The complete interface is shown
below.
41
9220-UM V1.2
Advertisement
Table of Contents
