Setting Up The Audio Options - Samsung DVD-VR335 Instruction Manual

Allows you to setup the audio device and sound status
settings depending on the audio system in use.
i
With the unit in Stop mode/No Disc mode, press
the MENU button.
| Digital Output
1. PCM : Converts to PCM(2CH) 48kHz audio.
Select PCM when using the Analog Audio
Outputs.
2. Bitstream : Converts to Dolby Digital Bitstream
Select Bitstream when using the
Digital Audio Outputs.
[] Be sure to select the correct Digital Output or
_t, no audio will be heard.
Press the AT buttons to select Setup, then press
the ENTER or _ button.
Press the AT buttons to select Audio, then press
the ENTER or _ button.
Audio setup menu wilt be displayed.
DTS
1. Off : Doesn't output digital signal.
2. On : Outputs DTS Bitstream via digital output
only. Select DTS when connecting to a DTS
Decoder.
[] When DTS soundtrack is played, sound is not
_t output from Analog Audio Output.
| Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1. On : When the Movie soundtracks are played at
low volume or from small speakers, the
system can apply appropriate compression
to make low-level content more intelligible
and prevent dramatic passages from getting
too loud.
2. Off : You can enjoy the movie with the standard
Dynamic Range.
iiiiiii
ii!ii! !
iii!i!i_;iiiii!i
.....
iiiiiiiiiii
Press the AT buttons to select the desired audio
option, then press the ENTER or _,-button.
Press the _T buttons to select the desired item,
then press the ENTER or _ button.
[] Press the RETURN or _1 button to return to the
previous menu.
Press the MENU button to exit the menu.
English - 37