Setting Up The Audio Options - Samsung DVD-HR725 Instruction Manual

Setting up the Audio
Options
You can connect the HDD & DVD RECORDER to an
external amp or Home theatre.
Allow you to setup the Audio device and sound status
depending on the audio system in use.
With the unit in Stop mode, press the MENU
1
button.
Press the ...† buttons to select Setup, then press
2
the OK or √ button.
HDD
Title System
Clock Set
Music
Language
Audio
Photo
Video
Parental Control
Programme
Install
Setup
MOVE SELECT
Press the ...† buttons to select Audio, then press
3
the OK or √ button.
Audio setup menu will be displayed.
HDD
Title Digital Output
DTS
Music
Dynamic Compression : On
V-Mode Compatibility
Photo
Programme
Setup
MOVE SELECT
Press the ...† buttons to select the desired audio
4
option, then press the OK or √ button.
Press the ...† buttons to select the desired item,
5
then press the OK or √ button.
Press the RETURN or œ button to return
to the previous menu.
NOTE
Press the MENU button to exit the menu.
Setup
√ √
√ √
√ √
√ √
√ √
√ √
√ √
RETURN EXIT
Audio
√ √
: PCM
√ √
: Off
√ √
√ √
: Off
RETURN EXIT
Digital Output
1. PCM : Select this when you have no
equipment that can decode Dolby
Digital (or MPEG-2) signal. When you
play Dolby Digital (or MPEG-2) sound
track, the digital output are converted to
PCM Stereo.
2. Bitstream : Output Dolby Digital (or MPEG-2)
audio as bitstream. Select this
when your AV receiver or AV
amplifier have Dolby Digital (or
MPEG-2) Decoder.
Digital output setting is equally applied to
both Dolby Digital and MPEG-2 audio.
NOTE
LPCM sound track is always outputted as
PCM. It has no relation with Digital
Output setting.
Be sure to select the correct Digital
Output or you will hear no sound or loud
noise.
DTS
1. Off : Doesn't output DTS signal. Select this
when your AV receiver or AV amplifier
does not have DTS decoder.
2. On : Outputs DTS Bitstream via digital output
when you play DTS track. Select this only
when your AV receiver (or AV amplifier)
have DTS decoder.
When DTS soundtrack is played, sound
does not output from AV Audio Output.
NOTE
Dynamic Compression
This is only active when a Dolby Digital signal is
detected.
1. On : When Movie soundtracks are played at
low volume or from smaller speakers, the
system can apply appropriate
compression to make low-level content
more intelligible and prevent dramatic
passages from getting too loud.
2. Off : You can enjoy the movie with the
standard Dynamic Range.
English - 37