Westinghouse Vision-Point MT25 ARM18 Install Manual page 7

If more or less tension is desired in the arm pivot points, do the following:
• To increase tension, turn socket screw clockwise with 3/16" allen wrench (G).
• To reduce tension, turn socket screw counterclockwise with allen wrench (G). Do not turn more than half a
turn.
SOCKET SCREWS
Place cable clips (B) as needed, to better manage cords, making sure that one clip is
close enough to the hinge area to prevent cord from bunching up.
Note: Make sure cords have enough slack to allow full movement of the arm.
B
7 of 8
ISSUED: 04-22-04 SHEET #: 095-9195-1
Visit the Westinghouse Web Site at www.westinghousedigital.com For customer service call 1-866-287-5555.