Advertisement
For Wood Stud Walls, use a stud finder to locate
center of stud. Make sure wall plate is level, drill two
3/16" (5 mm) dia. holes to a minimum depth of 2"
(51 mm). Attach wall plate to center of wood stud
using two #14 wood screws (I).
WARNING
• Tighten wood screws so that wall plate is firmly
attached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in • lb (9 N.M.).
• Make sure that mounting screws are anchored into the
center of the studs. The use of an "edge to edge" stud
finder is highly recommended.
Note: This product is designed to accommodate screens with VESA
mounting, please make sure that mounting screws turn at least three complete turns in the screen inserts.
FOR VESA 75 MOUNTING PATTERN:
1) Choose hole pattern indicated below. 2) Attach
adapter bracket (L) to back of screen using four
10 mm screws (M) as indicated below. 3) If hole
pattern is in a pocket, attach adapter bracket (L)
to back of screen using four 20 mm screws (N)
and four retaining spacers (O) as indicated below.
L
Visit the Westinghouse Web Site at www.westinghousedigital.com
®
compliant hole pattern. For safe
FOR VESA 100 MOUNTING PATTERN:
1) Choose hole pattern indicated below. 2) Attach adapter
bracket (L) to back of screen using four M4 x 10 mm
screws (M) as indicated below.
Note: If you don't get three complete turns in the screen
inserts, use four M4 x 12 mm screws (K) instead of four
M4 x 10 mm screws (M).
For screens with a hole
pattern in a pocket,
spacers (O) go between
adapter bracket (L) and
screen.
Note: LCD screen may
appear slightly different
than illustrated.
5 of 8
WALL
PLATE
I
L
ISSUED: 04-22-04 SHEET #: 095-9195-1
For customer service call 1-866-287-5555.
WOOD
STUD
WALL
Advertisement
