M M4 x .7 x 10 mm phillips screw M4 x .7 x 20 mm phillips screw .198" x .313" x .437" H retaining spacer Visit the Westinghouse Web Site at www.westinghousedigital.com Installation and Assembly - ™ Vision•Point...
Page 2
LINE "A" HALF WIDTH - 3/4" WALL PLATE ° OUTER EDGE OF CABINET Side of Cabinet Visit the Westinghouse Web Site at www.westinghousedigital.com WIDTH OF SCREEN Note: Make both lines "A" & "B" at a 90° angle with the cabinet.
Fasten wall arm assembly (A) to side of cabinet using two 1/4-20 flat head screws (C), washers (D), and 1/4-20 nylock nuts (E) as shown below. Skip to step 9. Visit the Westinghouse Web Site at www.westinghousedigital.com CENTERLINE OUTER EDGE...
Page 4
(up to 5/8" thick) must be counterbored as shown below. If plaster/drywall is thicker than 5/8", custom fasteners must be supplied by installer. Visit the Westinghouse Web Site at www.westinghousedigital.com WARNING fig 1.1 Drill hole and insert anchor (H).
Page 5
10 mm screws (M) as indicated below. 3) If hole pattern is in a pocket, attach adapter bracket (L) to back of screen using four 20 mm screws (N) and four retaining spacers (O) as indicated below. Visit the Westinghouse Web Site at www.westinghousedigital.com WALL PLATE ®...
Page 6
• Do not remove screw or loosen screw until it is no longer engaged with the mount. Doing so may cause the screen to fall. CAP SOCKET SCREW Visit the Westinghouse Web Site at www.westinghousedigital.com fig 2.1 1/4" WALL ARM...
Page 7
Note: Make sure cords have enough slack to allow full movement of the arm. 7 of 8 ISSUED: 04-22-04 SHEET #: 095-9195-1 Visit the Westinghouse Web Site at www.westinghousedigital.com For customer service call 1-866-287-5555.
Page 8
REPAIR OR REPLACEMENT – For a period of five (5) years from the original date of purchase, Westinghouse Digital Electronics will repair any defect in material or workmanship in the Product, or, at its option, replace a defective Product.