SelectBlinds Roller Shade Deluxe Spring Motor Manual

Roller Shade – Deluxe Spring Motor

Tools Required:

Tape measure, pencil, drill, drill bits,
screw driver, step stool or ladder.
Note: use a 5/64" drill bit to pre-drill the
screw holes (for attachment to a wall stud
or header board). Use Wall Anchors (not
included) for hollow dry wall or plaster
mounting.

Step 1. Mount the Brackets

The brackets can be face mounted, top
mounted or side mounted – attach the
brackets to the window frame, molding
or ceiling as illustrated. The brackets
are "universal" – there are no "right" and
"left" brackets.
Side Mount
Inside Window
Opening
Outside Window Opening
Mark the screw locations with a pencil
– pre-drill the screw holes using a 5/64"
drill bit.
Top Mount
Inside Window
Opening
or Ceiling Mount

Step 2. Install the Shade

Put the spring loaded pin into the round
hole of the bracket, push the spring
loaded tip into the bracket, and then
insert the hook arms on the opposite
side of the shade into the two hook arm
receiver holes of the bracket. Once the
two hook arms are through the holes,
gently pull down until the two hook arms
have locked securely to the bracket.
Pin End
Spring End