Installation Instructions - La Sommeliere LS6K Use Instruction

3. Installation Instructions

➢ Before using your thermoelectric cooler
▪ Remove the inner and outer packaging.
▪ Allow the appliance to rest for two hours before switching it on.
▪ Clean the inside using a soft cloth and lukewarm water.
➢ Installing your appliance
▪ This device is only intended to be installed in free standing, in no case it must
be installed in a built-in or embeddable way.
▪ Position it in a place with sufficient strength to support its weight when loaded.
To ensure that it is level, adjust the height of the feet underneath.
▪ To get the best from your appliance with the lowest energy consumption, do not
place the appliance close to a heat source (heater, cooker, etc.), do not expose
it to direct sunlight, and do not place it in a room which is too cold.
▪ Connect the appliance to a single socket, leaving a 10 cm gap between the back
of it and the wall and 2 cm on each side. Be careful to support it, so that it is
perfectly level. (Use of a spirit level is recommended). This will prevent any
movement due to instability, causing noise and vibration, and will ensure that
the door seals perfectly.
4. OPERATING INSTRUCTIONS
The appliance must be positioned in a room with an ideal ambient temperature
of between 20°C and 25°C.
If the ambient temperature is higher or lower, the appliance's performance may be
affected.
➢ To set temperature:
You can set the temperature of your cellar between 7 and 18 ° C
There are three touch-buttons on the control panel:
▪
and increases or decreases the set temperature.
18