Table of Contents
Advertisement
2.0
INTRODUCTION
This section describes the TimeView 230 mounting, switch
set-up, connection to a NetClock or computer synchroni-zation
source and manual set operation.
2.1
MOUNTING INSTRUCTIONS
The ancillary kit includes screws and plastic anchors for wall
mounting the clock. Tools needed for mounting are a Phillips
screwdriver and a 1/4" drill.
TimeView is designed to mount over a duplex outlet to conceal
the power adapter and data cables. For instal-lations where
this is not possible, notches are provided along the top and
bottom edges for routing power and data cables.
To install TimeView over a duplex outlet, lay a reference line
over the cover plate as shown in Figure 2-1. Drill two 1/4"
holes, eight inches apart, centered over the outlet.
INSTALLATION
Page 2-1
Advertisement
Table of Contents
Need help?
Do you have a question about the TimeView 230 and is the answer not in the manual?