Advertisement
LINE A Terminals
Available when LINE A / LINE B Change Switch on the front panel is
set to "LINE A".
[2] S-VIDEO IN/OUT
Connect S-VIDEO signal to {N terminal.
Terminals
The same signal is available at the OUT terminal.
[3] Impedance Change
Set this switch to 75Q
for the S-ViIDEO termination or to HI-Z for
Switch
bridge-connection to next unit.
[4] VIDEO IN/OUT
Connect video signal to IN terminal.
Terminals
The same signal is available at the OUT terminal.
[5} AUDIO IN/OUT
Connect audio signal to IN terminal.
Terminals
The same signal is available at the OUT terminal.
[6} VIDEO/S-VIDEO
Select
When the video signal is applied, set this switch to VIDEO position
Switch
and when the S-VIDEO signal is applied, set this switch to S-VIDEO
position.
|
LINE B Terminals
Available when LINE A / LINE B Change Switch on the front panel is
set-to "LINE B".
[8] VIDEO IN/OUT
Connect video signal to IN terminal.
Terminals
The same signal is available at the OUT terminal.
{9] AUDIO IN/OUT
Connect audio signal to IN terminal.
Terminals
The same signal is available at the OUT terminal.
EXT SYNC IN/OUT
Connect an external composite sync signal to this terminal when a
Terminals
non-composite video signal is applied to the video terminals ([4) or
(8).
Note: 1. The video and the external sync input/output terminals are equipped with "Automatic Termination
Switch". If only input signal is applied, they are terminated by 75ohm,
and if both input/output
signals applied, they are opened to high impedance.
2. It is possible to connect up to 10 monitors in series by looping through the S-VIDEO
IN and
$-VIDEO OUT or the VIDEO IN and VIDEO OUT terminals. There may be a possibility of a
brightness reduction or interference if more than 10 units are connected. Please carefully confirm
that these problems do not exist with the units before connection.
Advertisement
