Hills 80154973 Product Manual

Laundry basket holder

Download this manual

Operating your Laundry Basket

Holder

Folding away after use

If you would like to gain back your space after the washing has been put out, simply raise the

Hills Laundry Basket Holder upwards until it rests in the 90-degree position.

Securing a Peg Basket

Attach the optional O-Ring provided to your existing peg basket. We recommend attaching this

anywhere towards the opening of your peg basket to allow you to easily reach inside.

Once the O-Ring is attached to your peg basket, loop the ring onto the hook located on the

corner of the front bar of your Hills Laundry Basket Holder. This will comfortably hold up to 2kg

of weight.

Hills Contacts

We are committed to providing you with complete customer satisfaction. If you have any

questions or comments about our products or services please contact your nearest Customer

Service Centre during their local business hours:

Australia

1300 327 293

New Zealand

0800 021 027

hills@amesau.com

Hills Websites

Hills Home Living

hillshome.com.au

Hills Consumer Advice

hillshome.com.au/need-help

Ames Australasia Pty Ltd

ABN 89 169 427 061

Level 1, 660 Doncaster Road,

Doncaster Vic 3108 Australia

Laundry Basket Holder

Product Manual

80154973

Need help?

Do you have a question about the 80154973 and is the answer not in the manual?

Page 1 Once the O-Ring is attached to your peg basket, loop the ring onto the hook located on the corner of the front bar of your Hills Laundry Basket Holder. This will comfortably hold up to 2kg of weight.
Page 2 Laundry Basket Holder. of the Wall Bracket using 1 x Large M8x50 Bolt and 1 x Large Hex Key. Your Hills Laundry Basket Holder can be Note: When installing, ensure that the flat side of the rubber sleeve is facing upwards.
Page 3 Place 2 x Large M8 Nuts into the designated hex shape holes on the inside of the The Hills Laundry Basket Holder can be Pole-Mounted onto most rotary/ground mounted Wall Bracket. Ensure the Nuts are inserted as per Fig. 7 with the coloured rings clotheslines, or Wall-Mounted on masonry, brick or concrete walls.
Page 4 Pole-Mounted Installation Attaching the Pole Bracket to your clothesline Attaching the Arms to the Pole Bracket Place 2 x Large M8 Nuts into the designated hex shape holes on the inside of the LH Slide 1 x Arm End Cap onto 1 x Steel Arm. Refer to Fig. 4. Secure the Arm to the outside and RH Pole Brackets.