Section 6 - Adjustments; Parking Brake Adjustment - Scag Power Equipment LYBERTY Z SZL-36H-18FR Operator's Manual

R

6.1 PARKING BRAKE ADJUSTMENT

WARNING
Do not operate the mower if the parking brake is
not operable. Possible severe injury could result.
The parking brake linkage should be adjusted whenever the
parking brake lever is placed in the "ENGAGE" position and
the parking brake will not prevent the mower from moving.
If the following procedures do not allow you to engage
the parking brake properly, contact your Authorized Scag
Power Equipment Dealer for further brake adjustments.
1. Park the machine on a flat surface and block the
caster wheels to prevent the machine from moving.
Remove the ignition key.
2. Disengage the parking brake. See Figure 6-1.
3. Tilt the seat forward to gain access to the brake
control linkage.
4. Remove the cotter pin securing the pivot to the
brake control linkage. See Figure 6-2.
5. Push down on the brake control rod until it stops to
disengage the parking brake.
6. Adjust the pivot until it meets the mounting hole.
Insert the pivot into the brake control linkage and
secure with the cotter pin.
7. Repeat steps 4 thru 6 on the other side of the
machine.
8. Test the parking brake.
- NOTE -
If this procedure does not achieve proper brake
adjustment, please contact your authorized
Authorized Scag Power Equipment Dealer.
ADJUSTMENTS
REMOVE COTTER
26
RELEASE BRAKE
HANDLE
Figure 6-1. Brake Adjustment
PIN
ADJUST HERE
Figure 6-2. Brake Rod Adjustment
Section 6