KitchenAid KUDM220T Use And Care Manual page 17

Next, lift the removable filter straight up and
out. To clean, scrub filter with a stiff brush
under running water. To replace, snap
removable filter over the ultrafine filter and
then replace the wash arm. When replacing
wash arm, be sure that water jets on the
wash arm are facing up. Check to make sure
wash arm is free to rotate.
The Overflow Protection Float (G) in the
front left corner of the dishwasher tank
prevents the dishwasher from overflowing.
The float must be in place for the dishwasher
to operate.
Important: A small amount of water always
remains in the bottom of the dishwasher (un¬
der the ultrafine filter) to keep the seal moist.
The coarse strainer may be removed, if
necessary. To remove, lift strainer out by .
squeezing center section (F) and remove. To
replace, squeeze center section so clips snap Possible Burn Hazard
into square notch. Heating element will be hot immedi¬
ately following use. Do not touch. To
avoid burns wait at least 20 minutes
after a cycle for the heating element
to cool down.
17