PR AQUA Laser 260 BWS Manual page 6

Warning!
For safety, please run the safety cord
through its hole.
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 2 retainers attached
to each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the WARNING on the
underside of the base as shown above) To pass the SAFETY CORD through the HOLES for safety! Always ensure that the
projector is firmly anchored to avoid vibration and slipping whilst functioning.Always ensure that the structure that you are going
to mount the projector to is secure and strong enough to support the weight of a XR 1000 Framing.
WARNING:
The projector MUST be lifted or carried by the HANDLES instead of clamps.
●
.For safety the safety cord should afford 10 times the Projector's weight.
●
POWER CONNECTION
●
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Before power connection, please ensure the power supplied must match what the nameplate says. It is recommended that each
projector be connected with power separately so that they may be individually switched on and off.
The earth wire(yellow/green) must be connected to the ground. And electrical connection must be in
●
accordance with the standards concerned.
If any questions about the electrical installation, do not continue but consult a qualified electrician.
●
6
Note:
1. the distance between the foot of
the base and the front lens cover(the
head facing downward)
2. the distance between mounting
truss and the front lens cover( the
head facing downward)
3. The maximum diameter of the
rotating head ( minimum spacing
between fixtures)