Error Message - PR AQUA Laser 260 BWS Manual

Remarks:
1. Fan error can cause lamp-off.
2. Note: "Speed Mode" means Pan and Tilt will move from Point A to Point B at their respective maximum speeds."Time Mode"
means both Pan and Tilt will arrive at designated point at the same time. It's advised Time Mode be used if the projector runs
circles or in oblique lines.
8. ERROR MESSAGES
The system can detect some errors during the reset, if
The error messages are as follows:
Name
Pan
Tilt
Cyan
Yellow
Magenta
Color Wheel
Fixed gobo wheel
Rot. Gobo Wheel
Rot. Gobo Rotation
Dimmer
Prism
Prism Rotation
Focus
Zoom
Fan
Pan Board
Tilt Board
Motor Driver Board 1
Type
Timeout/magnet
Sensor/Encoder
Timeout/magnet
Sensor/Encoder
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout/magnet Sensor
Timeout
Error
Error
Error
Error
Slow Dimmer
057-058
Reserved
059-089
090-094 Pan & Tilt Speed Mode
095-099 Pan & Tilt Time Mode
100-139 Reserved
Pan & Tilt Reset
140-149
150-159 Color System Reset
160-169 Gobo Wheel Reset
Reserved
170-179
Focus/Prism /Zoom/Frst Reset
180-189
190-199 Reserved
200-209 Total Reset
Reserved
210-255
displayed, touch to view the error.
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if wiring, positioning parts and motors are normal
Check if fan and its wiring are normal
Check signal wire
Check signal wire
Check signal wire
19
Correction