Thermador Professional PH Series Installation Manual page 6

CAUTION: The supplied transition mounts to the top or rear of the
. . a. hood depending on the discharge direction.
Vent unit to the outside of building only.
1. Align mounting holes at base of transition with
mounting holes on 1/2" flange located at the top or rear
The hood can be mounted on a wall or suspended from a of the hood, depending on direction of discharge.
cabinet. Both vertical and horizontal discharge are possible . }
with either mounting method. 2. Fasten transition to hood using two (2) # 8 sheet metal
screws (included with hood).
3. Seal connection between transition and hood with duct
; ; . 4. Remove tape holding damper closed.
The hood is shipped ready for vertical discharge. To
change to horizontal discharge, move the discharge cover
shown in Figure 1 to the top of the hood. The plate is held
in place by four (4) screws.
See Figure 2 for overall hood dimensions.
This opening
is covered for
horizontal
discharge
24", 27"
This opening
is covered
for vertical
discharge Figure 2: Overall Dimensions
*Varies by model.
Figure 1: Discharge Direction
Note:
Read Remote Control Installation Instructions before
continuing if using this accessory.
English 4