Sony HANDYCAM DCR-SR40 Operating Manual page 11

To chargethe batterypack usingonly
the ACAdaptor
Slide the POWER s'a itch up tu OFF (CHC),
then cunuect tile AC Adaptor directly to tile
DC IN jack on the camcorder.
POWER switch
DCIN
jack
DC plug
Open the jack cover
Charging time:
Approximate time (min.) required when you
fully charge a completely exhausted battery
pack.
Recording/Playback time:
Appruximate time (min.) available when you
use a fully charged battery pack.
(Unit:rain.)
Charging time 125 125
Recording time .1
Conlinuous 100"2
recording lime 125 105.3
Typical 65 55*2
recording time*4 55*3
Playback time 140 115 *2
.1 When [REC MODEl is set lo [HQ],
*2 When the LCD backlight turns on.
*3When the LCD backligla lurns off.
*4 Typical recording time shows the lime when you
repeat recording slarl/slop, turning lhe power on/
off and
zoonlillg,
On the battery pack
• Before chmlging the baUery pack, slMe tile
POWER
swilch
IO OFF
(CHG).
• The power will not be supplied li'om the battery
as hmg as the AC Adaptor is connected lo the DC
IN jack of your camcorder, even when the power
cord is rcnloved l)oln tile wall oul]et,
On the charging/recording/playback time
• Times measured with tile canlcorder at 25°C
(77°F). (10-30°C (50-86°F) is reconnnended.) €0
• Available recording and playback lime will be =
shorter when you rise yotlr camcorder in low
telllperalures. _"
• Tile avaihtble recording and playback time will __
be shorter depending on tile conditions under
w]licb yoll use yollr calllcorder.
On the AC Adaptor
• Connect tile AC Adaplor lo all easily accessible
wall outlet close by. If any trouble occurs while
using the adaptor, innnediately shul ol/lhe power
by removing the plug tronl the wall outlet.
• Do not use the AC Adaplor placed in a narrow
space, such as between a wall and fllmiture.
• Do not short-circud the DC plug of the AC
Adaptor or bauery lerminal with any nletallic
ot_iects. This may cause a malhmction.
PRECAUTION
• E_en if your canlcorder is turned oil AC power
(house current) is still supplied lo it while
connecled lo lhe wall outlet via the AC Adaptor.
Power supply
You can use your Calllcorder ill ally COUlllries/
regions using the AC Adaptor supplied with your
canlcorder within the AC 100 V to 240 V, 50/60 Hz
range.
Use a conmlercially available AC plug adaptor [a],
if necessary, depending on the design of tile wall
outlet [b],
AC-L25A/ L25B
[a] [b]
11