Turning The Appliance On / Off; Changing Operating Mode - Makita VC010G Instruction Manual

Switch action
Fig.18
► 1. Mode change button 2. ON / OFF button

Turning the appliance on / off

Press the ON / OFF button to turn the appliance on and off.
CAUTION:
Always put the head of the appli-
ance on the floor when turning on the appliance.
Otherwise an accident due to entanglement may
occur and cause a personal injury.

Changing operating mode

There are the following three operating modes:
1. Low noise level
2. Normal
3. High
To change the operating mode, press the mode change button.
The operating mode can be changed even when the appliance
is turned off. The appliance will start in the mode you set.
NOTE: The cleaner starts in the same mode as the
last operation. If you remove the battery while the
motor is running after the shutdown, the cleaner may
not start in the same mode as the last operation.
Turning lamp on / off
CAUTION:
Do not look in the light or see the
source of light directly.
The appliance is equipped with the lamps.
See the paragraph of the battery check / lamp button for operation.
1
Fig.19
► 1. Lamp
Foot lever
CAUTION:
upright position when you let go of the handle.
1
Otherwise the appliance may accidentally fall and
cause injury.
2
CAUTION:
gers between the main body and the head of the
appliance.
To unlock the upright position of the appliance, step on
the foot lever and pull the handle backward.
The range of motion is 90 degrees from the upright
position.
Fig.20
► 1. Foot lever
To lock the appliance in upright position, raise up the
handle forward until the foot lever locks the position
with click.
Fig.21
12 ENGLISH
Always lock the appliance in
Be careful not to pinch your fin-
1