Installation Instructions - GE Monogram ZIC30GNZAII Installation Instructions Manual

Installation Instructions
TOOLS REQUIRED
@ 5/32" Allen wrench
e Utility knife
¢ Stepladder
* Bucket
* Level
¢ Appliance hand truck
¢ Tubing cutter
« 7/16" open-end wrench
« 1-5/16" open-end wrench
* #2 Phillips screwdriver
¢ Drilland bit set
« 5/16" socket
e Safety glasses
* Pliers
« 3/8" ratchet
* Torx T-20, T-30 wrench
HARDWARE SUPPLIED
e Anti-tip bracket & screws
¢ Panel mounting brackets
¢ Door panel templates- Pub # 31-46543
« Water filter - Part # GSWF
¢ Drywall Anchors and screws
MATERIALS REQUIRED
« 1/4" copper water line tubing or GE SmartConnect™
Refrigerator Tubing kits
« Water shut-off valve
* Custom panels for fresh food door, freezer drawer
and Convertible drawer
« Velcro w/adhesive if using custom toekick.
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that is at
the same height as the rest of the flooring. This
surface should be strong enough to support a fully
loaded refrigerator, or approximately 1,200 Ibs.
NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under
the refrigerator where you are working.
12