Step 2, Install Anti-Tio Bracket; Step 4, Connect Power W - GE Monogram ZIC30GNZAII Installation Instructions Manual

Installation Instructions
STEP 2| INSTALL ANTI-TIP BRACKET
* Inside Top Face of bracket should be installed at 80".
"Slot" in bracket should to be placed in center of install
Space (Typically 15")
@ Mark (within slots, placement) stud and anchor positions
on brackets.
/ 80"
Slot
~~
eSecure bracket using combination of studs & anchors.
*At least 1 stud must be engaged.However, please engage
as many studs as possible within the enclosure. A mininum
of three fasteners should be used for proper installation.
14
STEP 3 | CONNECT WATER LINE
ae
_.!
—S
W w
* Position appliance in front of enclosure.
* Locate and bring tubing to the front of the cabinet.
* Turn the water on to flush debris from line. Run about
a quart of water through tubing into a bucket; then
shut off water.
Water
Line Hole
If needed cut the tubing to the proper length so tt can
be attached to the water valve.
Copper Tubing:
@ Slip a 1/4" nut and ferrule over both ends
of the copper tubing. Insert tube into the union fitting
on the unit and tighten nut to union.
* Turn on the water to check for leaks.
GE SmartConnect™ Tubing:
Insert the end of the tubing into the refrigerator
connection. Tighten the compression nut until it is just
hand-tight.
¢ Tighten one additional turn with a wrench.
Overtightening can cause leaks!
* Turn on the water to check for leaks.
STEP 4 |CONNECT POWER
* Plug the power cord into the socket.
# Check to make sure power to refrigerator is on by
opening the ice drawer (FF door will be banded shut)
to see if interior lights are on.
* The temperature controls are preset at 37°F for the
fresh food section and O°F in both the freezer drawer
and customizable drawer.
¢ Allow 24 hours to stabilize before making
adjustments.