Error Messages - Rinnai RHFE-1004FA Owners & Installation Manual

ERROR MESSAGES
_The Energysaver 1004 has the abilityto check its own operation continuously. If a fault occurs, an Error Message
will flash on the Digital Display of the controlpanel. This assists with diagnosingthe fault, and may enable you to |
overcome a problem without a service call. Please quote the code displayed when inquiring about service, j
FAULT REMEDY
Check gas is turned ON.
Ignition failure Service call if repeated.
Flame failure Check gas is turned ON.
Service call if repeated.
Clean filter
Overheat Service call if repeated.
Lower room temperature
Room overheat to lessthan 40°C(104°F).
CODE DISPLAYED
11
12
14
16
31
32
33
34
53
61
70
71
72
73
49
99
Room Temperature
Sensor faulty
Overheat Temperature
Sensor faulty
Service call.
Service call.
Sparker failure Service call.
Combustion fan failure Service call.
Faulty ON/OFF switch Service call.
Faulty solenoids Service call.
Faulty Flame Rod Service caII.
Communication Error Turn heater OFF,
then ON again.
Sensor breakdown Service Call.
Flue block Check around flue terminal
I In all cases, you may be able to clear the Error Message simply by tuming the heater OFF, then ON again. '_
J
If the Error Message s_ll remains or returns on the next operation, contact Rinnai or your nearest sewice
agent and arrange for a service call.
m33m