Rinnai RHFE-1004FA Owners & Installation Manual page 27

ROOM TEMPERATURE DISPLAY
'Temperature is indicated by the L.E.D. display on the control
panel. The first time when the appliance is turned on, the preset
temperature '72 F degrees'(from the factory) will be shown on
the L.E.D.display. Every time the Set Temp has been
changed,that set temperature will be latest data appearing on
the L.E.D. display on the next time the appliance is turned on.
To get to Set Temp,press either' up' or' down ' button. At the
Set Temp, press ' up ' to increase the temperature or ' down ' to
decrease. When the desired temperature is set, 10 seconds
later the LED display will change to the room temperature mode
which will show the current room temperature.
Set Temp ©
Room Temp O
I(_ Temp _1
Control
[ ,tO J
Function Lock
TO TURN UNIT OFF
Depress ignition ON/OFF button again.
The appliance will stop operate.
Do not turn off by unplugging at the power outlet.
Convection fan continues to run until heater is cool.
IGNITION BUTTON
ECONOMY BUTrON
To select 'Economy Mode', push the 'Economy' button,
the green lamp will glow. 30 minutes after the room
temperature reaches the preset temperature (set by the
thermostat), the 'Economy Mode' if set, reduces the
temperature by 2°F, after another 30 minutes it reduces
the temperature by a further 2°F. This is an energy
saving feature. It does not operate if the heater is under
capacity for the room size.
ECONOMY
©
'_
T Cc
Funct
FILTER LAMP
If the filter lamp glows dudng operation, check air filter
for dust. If there is dust present, clean filter. See
section on care of heater. Turn heater off before
cleaning filters.
Filter 0N-
0
- 25 -