Device Control - Holzworth Instrumentation HSM Series Quick Start Operation Manual

DEVICE CONTROL

Once you are properly connected, the SET menu window is available and the GUI default
values are a 100 MHz carrier frequency at 0 dBm power and 0° phase offset.
Check the unit is operating with a spectrum analyzer, phase noise analyzer, or oscilloscope to
verify the output signal.
To change any setting, click on a digit in the appropriate window and the number will be
highlighted (figure above). Enter the desired value and press return on the PC keyboard. Other
digits can be modified by using the mouse, or the right and left arrow keys.
HSM Series Quick Start Guide holzworth.com 5