Advertisement
ASSEMBLY
Assembly requires two people. Place all parts of the PROFORM ®485E in a cleared area and remove the
packing matedals. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver _,
two adjustable wrenches _,
and a rubber
mallet _.
1. Feed the console wire down through the Upright (3)
as shown. While another person holds the Upright
near the Frame (1), tie the console wire and the
Sensor Wire (25) together as shown in drawing la.
Next, connect the console wire to the Sensor Wire.
Gently pull the Resistance Cable (26) and the
console wire out of the top of the Upright (3) until
there is no slack between the Upright and the
Frame (1).
Slide the Upright (3) onto the welded bolts on the
Frame (1). Be careful to avoid pinching the
Resistance Cable (26) and the Sensor Wire (25).
Tighten a 3/8" Nylon Locknut (29) onto each welded
bolt.
2.
Feed the console wire back down into the Upright (3).
Attach the Console (6) to the Upright with four #8 x
3/4" Round Head Screws (16). Be careful to avoid
plnchlng the console wire.
Press the Resistance Knob (50) onto the Resistance
Control (26).
la
Wire_
Console
25
29
Console
I
_'_-_S,I
Console
_---_'116
_3
6Wire
6
Advertisement
