Advertisement
3. Find the Left Pedal (31), which has a ridge on the
fight side. Attach the Left Pedal to one of the Pedal
Arms (12) with three #8 x 3/4" Round Head Screws
(16) as shown.
Repeat this step to attach the Right Pedal to the other
Pedal Arm (not shown).
4.
Make sure that there are two Pedal Arm Bushings
(42) in each Pedal Arm (12).
Slide a Handlebar Spacer (39) and the Pedal Arm (12)
with the Left Pedal (31) onto a Handlebar (8) as
shown. (Note: These parts fit tightly; it may be helpful
to use the rubber mallet). Refer to the PART
IDENTIFICATION
CHART on page 5 and identify the
3/4" Axle Caps (43). Tap a 3/4" Axle Cap onto the
Handlebar.
Repeat this step to attach the other Pedal Arm (12) to
the other Handlebar (8).
5.
Make sure that there are two Rear Pedal Arm
Bushings (11) in each Pedal Arm (12).
Slide a Pedal Arm Spacer (41) and the left Pedal Arm
(12) onto the left Crank Arm (59) (these pads fit tight-
ly; it may be helpful to use the rubber mallet). Be
careful not to confuse the left Pedal Arm with the
right Pedal Arm (not shown); look at the position
of the left Handlebar (8) to Identify the left Pedal
Arm.
Tap a 3/4" Axle Cap (43) onto the left Crank Arm (59).
Repeat this step to attach the right Pedal Arm (not
shown).
r
3
31
16
42
31
8
/
12
12
41
12
43
7
Advertisement
