Advertisement
ASSEMBLY
Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed. Assembly requires a phillips screwdriver,
and two adjustable wrenches.
1. Slide the bracket on the Rear Stabilizer (2) into the
Frame (1), and secure it with four Stabilizer Screws
(32).
2. Align the Front Stabilizer (5) with the saddle bracket
on the front end of the Frame (1). Note: Make sure
the square holes in the Stabilizer are facing
away from the saddle bracket. Attach the
Stabilizer with two Stabilizer Carriage Bolts (18),
two Flat Washers (14) and two Stabilizer Nuts (80).
3. Slide the Left Handlebar (40) into the left handlebar
post on the Frame (1), Slide the Right Handlebar
(41) into the right handlebar post. Slide the Top
Handlebar (3) onto the Left and Right Handlebars
and secure it with two Handlebar Screws (33).
Stide the Handlebar (3) into the handlebar post on
the Frame (1). Be sure that the holes in the
Handlebar and the handlebar post line up. Attach
the Handlebar with four Handlebar Bolts (36), four
Handlebar Washers (38) and four Locknuts (37).
Note: the Locknuts will fit into the hexagonal holes
in the handlebar post.
//
Square Holes
18
3
,_r-----33
.
4
Advertisement
