Advertisement
PREPARATIONS
POWER SOURCE
Outdoor Use :
For outdoor
recording, use supplied
battery pack NP-55.
Attaching the Battery Pack
1.
Align the iine on the battery pack with the unit.
2.
Gently press the battery pack toward the unit, then slide
it to the right, until it "clicks" into place (arrow 6).
Removing the Battery Pack
1.
Press and hold down the battery eject lever (arrow G9).
2.
Slide the battery pack to the left (arrow 6).
Indoor Use :
For indoor recording, use supplied AC adaptor VAR-30B or
VAR-30C.
a)
Attach (or remove) the power connection cord using the
procedures in steps 1 and 2 above "Attaching the Battery
Pack"
(or "Removing
the battery pack").
b)
Connect the AC adaptor's plug to an AC outlet. The green
IMPORTANT
power
lamp will light.
The wires
in this mains
lead are coloured
in
c)
When finished recording or playback, disconnect the AC
accordance with the following code:
adaptor's plug from the wall outlet.
The AC adaptor can be used in countries with line voltages
Blue:
— Neutral
between 100 V AC and 240 V AC.
EE
Lee
As the colours of the wires in the mains lead
of tnis apparatus
may not correspond
with
the
coloured
markings
identifying
the
terminals
in your plug proceed
as follows.
The
wire
which
is coloured
blue
must
be
connected
to the terminal which
is marked
with the letter N or coloured
blue or black.
The wire which
is coloured
brown
must
be
connected
to the terminal which
is marked
with the letter L or coloured
brown
or red.
To DC OUT terminal
Power connection
cord
Notes :
.
@ The battery pack supplied with this unit has not been charged. Charge it before initial use. (See page 5)
eDo not use VAR-30B or VAR-30C AC adaptor to supply power for other than VM-D6P 8mm camcorder.
€ When
removing the battery pack or power connection
cord, power should be switched OFF.
Advertisement
